Product Description
Every Garmin product is designed to meet the most demanding standard: customers' satisfaction. That's why Garmin equipment is manufactured to give you reliable service for years to come, with intuitive features you can grow into over time - all at a price you can afford.
Amazon.com Product Description
Lightweight, portable, and adjustable, the Garmin automotive mounting bracket is designed for use with GPSMAP 60C. Featuring a permanent disk to securely attach your mount, the bracket is jointed, allowing your GPS to be positioned out of the sun's glare. It also comes with a full manufacturer's warranty.
Customer Reviews:
Works well and reasonably priced.......2007-09-23
This dashboard mount is probably the best choice for putting a 60C series Garmin in a boat or automobile, especially in California, where the windshield suction cup mount is illegal.
What I like about the product:
1. At $18~$24 current street price, it's an attractive accessory for Garmin 60C owners.
2. It works pretty good on paved roads. I suspect that it is probably not strong or rigid enough for use on rough gravel roads or when crossing open terrain.
3. Allows attachment of Garmin 12 volt auto power cord and external antenna cable.
4. You can access all 60CX control buttons (but not the battery cmpartment door)
Possible problems with this product:
1. My 60CX is a very tight fit in this mount, which might be good to ensure that it doesn't come loose and fall, but makes me wonder if the plastic can stand up to more than a few dozen cycles of attachment and removal of the GPS before it breaks from fatigue.
2. The mount is all made of a black plastic that looks like it would absorb a lot of heat and damaging UV rays on a car dashboard. Recommend owners of this mount keep it covered with a light colored cloth when the car is parked outdoors.
3. The base of this mount, with it's adhesive pad, requires a clean, FLAT, approximately horizontal surface. It WILL NOT work on even mildly curved dashboards. Make sure your car's dashboard has a FLAT area at least 2" x 3" inches, in a location that will be suitable for mounting the GPS, before you buy this mounting.
If you can't find a flat enough surface, you could still attach this mount with screws instead of the adhesive pad, after building up a flat surface on the dash with Bondo or a similar product. This assumes you have an older car that is already dinged up enough that you won't mind making a couple more small screw holes in the dash.
NOTE: You MUST NOT use this mounting in any place on the dash or steering column where it could be in the path of deployment of any of your car's airbags.
GPS Holder doesn't work.......2007-05-31
I bought this item because I wanted to use it in a rental car for a trip on the east coast. It required a flat surface in the car. The one I rented didn't have one. I ended up holding the GPS in my hand the whole time.
I should have bought the windshield suction cup version however I noticed that it was illegal in a couple of states.
I think Garmin produced this product to satisfy the legal department.
Great product.......2007-01-09
This product works as advertised. Holds my Garmin 60Cx in place and arm is fully adjustable to angle GPS towards me while I drive. Mount holds the GPS almost too tightly. It'd be nice if the GPS could be put into and removed from the mount with one hand.
note on the garmin dash mount.......2006-07-21
so far (few days) this seems to work fine..a little "bouncy" with the arm fully extended, but that's just the nature of it. (everyone may not extend the arm the way I did, but it lets you if you want).
It does adjust to just about any angle you need, and in that way is very flexible in its design (3 adjustments, one for how far the arm extends, a second for tilt of the unit front to back and a third for rotation of the unit, e.g. if the base is not mounted on a spot on your dash level to the ground). The permanent adhesive seems to be working well (the temporary adhesive didn't last in the 100+ degree heat direct sun from our heat wave, but worked ok until it got that hot).
one important clarification to a below review - this unit, Garmin 010-10456-00, comes with the base you need to mount it on your dash. (it's really three parts - the clip for your gps, the rotating / adjusting arm and the swivel base that attaches to your dash). so, contrary to the below earlier dated review, you don't need anything additional for this mount.
however, if you'd like to mount this unit in a second vehicle, you can purchase either a second swivel base (e.g. just the base that sticks to your dask) separately, or the weighted base, kind of a bean bag with the swivel base attached. Both of those are the base only and require you to already have the arm and clip for the GPS which come in this package, but let you buy only a new base without having to buy the clip and arm over again.
Works very well.......2006-03-16
The mounting bracket works very well as long as you use the permanent mounting adhesive. The temporary adhesive would not stick to my dash very well. The mount is a little springy when driving if left sticking up in the air, not much but a little because of the weight of the GPS. I solved this by adjusting the mount so that the bottom of the GPS rests on the dash. Once I did this the mount is firm and stable and does the job quite well.
Product Description
The SmartMount for 32" to 50" flat panel screens provides a versatile and secure solution for professional environments such as boardrooms, hotels and stadiums. This mount offers smooth, continuous one touch tilt, allowing for easy adjustment to achieve the perfect viewing angle without tools. The mount includes simple to align universal brackets and a unique wall plate that can be mounted to two wood studs up to 24" apart, or concrete. For easy installation the mount is preassembled and includes a Sorted-For-You baffle pack with all screen hardware and security fasteners.
Customer Reviews:
Peerless ST650P Tilting Wall Mount 32"-50".......2007-12-27
Bought two of these for 46" LCDs. Heavy Duty and very secure once mounted. Two considerations. Plug in all connections to tv before hanging on bracket. Need small hands to adjust manual thumbscrews for tilting.Looks great on the wall.
Easy Install, yet Disappointing Tilt.......2007-12-27
I bought this wall mount for my Sony Bravia 46" LCD, which I also purchased at Amazon. It was an easy install using the enclosed hardware and following the directions. Didn't take long before it was up.
The description stated tilting wall mount, so I bought it instead of the regular one, which was a little cheaper. I guess I should have read the description more thoroughly. It only tilts downward at a very slight angle, but more upwward. I would assume that most people tilt downward, as they probably hang them above fireplaces, etc. Therefore, I was hoping (assumed) to have a bit more tilt.
I'm not dissatisfied whatsoever with the product. But I could have paid less with the same result. Overall it was a good purchase.
Great Mount for Sharp Aquos.......2007-12-25
The mount worked very well. It was easy to install and had great instructions which covered every possible configuration.
Compared to the overly expensive models at the retail stores in my area this price could not be beat.
Great Bracket for your Flat Panel.......2007-12-25
I installed this bracket in about 2 hrs. with my dad's help. I put a 32" Sharp Aquos on it. It was really easy to get on the wall and then place the LCD panel on it. The only thing I regret is that it doesn't allow me to get to the back of my unit without having to uninstall it. Luckily all my component and HDMI slots were used up, so now when I get a new item, I just replace it with whatever I'm discarding.
Good Mount.......2007-12-25
I bought this to go with my Toshiba 47HL167 LCD TV. It hooks up easily, comes with an amazing number of bolts so it can hook up to any TV; but they are separated in nice little pouches so finding what you need is easy. It attaches to a stud wall with 4 screws and installation is quick.
This is the only mount I've used, but I can't see what a $150 mount would offer you. So long as it doesn't crash off the wall - that's really all you need. It also pivots but I set mine vertical.
The hardest part was deciding where to mount it. I used blue painters tape to layout a 'TV' on the wall and looked at it from lots of angles, chairs, sofas, etc. My first inclination was to go too high, I found that was uncomfortable on the neck. Final TV center height is 50". This is comfortable to look at from a chair, but also high enough to view while laying on a couch (and looking above your feet). But your room and furniture will be different - so try the "tape" TV for 30 minutes of so.
Product Description
Low Profile 1.25 inches deep / 30-50 inch Flat Panel / Supports up to 130 pounds / Safety Bolt / Universal Mounting Pattern / Heavy Guage Steel / Black Mounting hardware included Low profile allows TV to be mounted just 1.25 inch from wall Simply attach two universal mounting brackets to TV and hang on wall mounting plate Safety bolt locks mount securely in place on wall Low profile flat panel TV wall mount in black Width 28.75 x Depth 1.25 x Height 18.5 inches
Customer Reviews:
one important note.......2007-12-27
Great wall mount. But it must be mounted on two wood studs at least 12" apart. If your Flat screen is under 40" you can us the Sanus ML22. This is a single stud wall mount.
It's lockable!.......2007-11-29
First off this is a great mount, it's been said over and over. What hasn't been mentioned and was a deciding factor for me is the ability to lock your tv to the wall. Not all of the mounts out there have this feature. I did a lot of research and I found nothing comparable at this price point. The locking feature is simple yet effective. Do you see the little hole in the bottom left corner of the portion of the mount that attaches to the wall? That is a where you put your lock and is part of the bar that slides into the mount after you have attached the tv to the wall mount. Once this bar is in, you can not lift your tv off the mount. To remove the tv, you remove this bar. If the lock is on the bar, the tv does not come off. (lock not included) It works great for me. The setup was very smooth, 5 stars!
Great Product!.......2007-08-01
Top of the line product...wall mount is made of solid steel and holds my TV without any worry of falling off. If your looking for a wall mount this is the one to get.
Why pay more!!!.......2007-05-12
I do a lot of research online and in store comparisons before I buy most of my items. The wall mounts in stores like CC and BB are all overpriced. I read the reviews on Amazon and made my decision to go with this model. The mount arrived in like 2 days and it took a total of maybe 15min to hang. The product is built well and comes with everything you need. Why pay over a hundred or two hundred dollars for a piece of metal to hang your tv. I tested the product by hanging from it and I weigh 180lbs, it did not budge. It sits flush and works as described. Do not waste your money on something else that does the same thing.
Just what I was looking for :).......2007-04-11
This is what I was looking for. A low profile mount for my Hitachi 42" plasma tv that is really strong for a reasonable price.
It comes with everything you need, it doesn't matter if your tv's back is round or flat, or what kind of wall your house has. Even it comes with a security bar to put a lock on it.
I really recommend you this product, just what i was needing.
Cheap Consumer Electronics:
- Garmin to HP iPAQ GPS Data Connectivity Cable (Round Connector)
- Green 2gb 2nd Generation Mutimedia Audio/Video/FM Player
- HP N6010 Scanjet Document Sheet-feed Scanner
- i2Go eGo 32MB MP3 Player (Blue)
- iRiver 1T604BL T60 4 GB MP3 Player (Black)
- Iriver Clix2 Clix 4gb (U20) - 2nd Generation - Portable Multimedia Player (Black)
- iRiver Clix Rhapsody 4GB Digital Music and Video Player
- iRiver U10 1 GB Music&Video Player
- Irok MP3 PLAYER/1GB Batt Recording/oled DISPLAY/FM/USB2.0
- Joybee 125 MP3 Player, 128MB, Black (DA125-128MB-Black)
Cheap Consumer Electronics List
Cheap Consumer Electronics
GPS Accessories & Components
|
Garmin
|
Custom Brands
|
Custom Stores
|
Specialty Stores
|
Electronics Features
|
Electronics
Garmin Handlebar Mounting Unit for GPS 60 Series
Garmin GPSMap 60CSx 2.6-Inch Mapping Handheld GPS
Garmin Protective Case for GPSMap 60C and 60CS (010-10578-00)
Garmin Three-Finger Friction Mount for Garmin GPS Units (010-10503-01)
Garmin Portable Friction Mount for Garmin GPS Units (010-10306-00)
Garmin Carrying Case for eTrex and Summit (010-10314-00)
Garmin Forerunner 50 with Heart Rate Monitor
Garmin 16MB Memory Cartridge for eMap or StreetPilot
Garmin GPS 152i with Internal Antenna
Garmin Marine Mount for Garmin GPSMAP 76
